Ad
related to: how to build a cutting table
Search results
Results from the WOW.Com Content Network
Guillotine cutting is the process of producing small rectangular items of fixed dimensions from a given large rectangular sheet, using only guillotine-cuts. A guillotine-cut (also called an edge-to-edge cut) is a straight bisecting line going from one edge of an existing rectangle to the opposite edge, similarly to a paper guillotine.
Henry Maudslay's early screw-cutting lathes of circa 1797 and 1800.. A screw-cutting lathe is a machine (specifically, a lathe) capable of cutting very accurate screw threads via single-point screw-cutting, which is the process of guiding the linear motion of the tool bit in a precisely known ratio to the rotating motion of the workpiece.
A sidehill cut can be formed by means of sidecasting, i.e., cutting on the high side balanced by moving the material to build up the low side to achieve a flat surface for the route. In contrast, through cuts, where the adjacent grade is higher on both sides of the route, require removal of material from the area since it cannot be dumped ...
Cutting tool materials are materials that are used to make cutting tools which are used in machining (drill bits, tool bits, milling cutters, etc.) but not other cutting tools like knives or punches. Cutting tool materials must be harder than the material of the workpiece, even at high temperatures during the process.
Tunnel Construction. Tunnels are dug in types of materials varying from soft clay to hard rock. The method of tunnel construction depends on such factors as the ground conditions, the ground water conditions, the length and diameter of the tunnel drive, the depth of the tunnel, the logistics of supporting the tunnel excavation, the final use and shape of the tunnel and appropriate risk management.
A static cutting table is a type of cutting plotter used a large flat vacuum table. It is used for cutting non-rigid and porous material such as textiles, foam, or leather, that may be too difficult or impossible to cut with roll-fed plotters.
Ad
related to: how to build a cutting table