enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Riving knife - Wikipedia

   en.wikipedia.org/wiki/Riving_knife

   Riving knife. A riving knife to the left of the blade on table saw. A riving knife is a safety device installed on a table saw, circular saw, or radial arm saw used for woodworking. Attached to the saw's arbor, it is fixed relative to the blade and moves with it as blade depth is adjusted. [1]

3. Fretsaw - Wikipedia

   en.wikipedia.org/wiki/Fretsaw

   A cutting or fretwork table, also known as a V-board, made of either wood or metal and which clamps to the edge of the workbench, may be used to support the work piece whilst allowing clearance for the saw blade by means of a V-shaped slot cut into it. The blade is usually clamped into position using a pair of wingnuts. Although wing nuts are ...

4. Plywood - Wikipedia

   en.wikipedia.org/wiki/Plywood

   Plywood for flooring applications is often tongue and groove (T&G); This prevents one board from moving up or down relative to its neighbor, providing a solid-feeling floor when the joints do not lie over joists. T&G plywood is usually found in the 13-to-25-millimetre (1 ⁄ 2 to 1 in) range.

5. These Portable and Stationary Table Saws Are Guaranteed ... - AOL

   www.aol.com/lifestyle/7-best-table-saws-maximum...

   Its 52-inch rip capacity covers a range of cutting tasks, from small cross-cuts of dimensional lumber to shaping large 4x8 foot plywood sheets, and its 449-pound cast iron construction provides an ...

6. Stitch and glue - Wikipedia

   en.wikipedia.org/wiki/Stitch_and_glue

   Stitch and glue is a simple boat building method which uses plywood panels temporarily stitched together, typically with wire or zip-ties, and glued together permanently with epoxy resin. This type of construction can eliminate much of the need for frames or ribs. [1] Plywood panels are cut to shape and stitched together to form an accurate ...

7. Sawhorse - Wikipedia

   en.wikipedia.org/wiki/Sawhorse

   Sawhorse. Diagram of a sawhorse. A folding sawhorse. In woodworking, a saw-horse or sawhorse (saw-buck, trestle, buck) [1] is a trestle structure used to support a board or plank for sawing. A pair of sawhorses can support a plank, forming a scaffold. [2] In certain circles, it is also known as a mule and a short sawhorse is known as a pony.

8. Router table (woodworking) - Wikipedia

   en.wikipedia.org/wiki/Router_table_(woodworking)

   A router table is a stationary woodworking machine in which a vertically oriented spindle of a woodworking router protrudes from the machine table and can be spun at speeds typically between 3000 and 24,000 rpm. Cutter heads ( router bits) may be mounted in the spindle chuck. As the workpiece is fed into the machine, the cutters mold a profile ...

9. Boat building - Wikipedia

   en.wikipedia.org/wiki/Boat_building

   A subdivision of the sheet plywood boat building method is known as the stitch-and-glue method, [8] where pre-shaped panels of plywood are drawn together then edge glued and reinforced with fibreglass without the use of a frame. [9] Metal or plastic ties, nylon fishing line or copper wires pull curved flat panels into three-dimensional curved ...