enow.com Web Search

  1. Ads

    related to: metal lock rings

Search results

    1,161.22-9.65 (-0.82%)

    at Thu, May 30, 2024, 5:15PM EDT - U.S. markets closed

    Delayed Quote

    • Open 1,162.72
    • High 1,164.94
    • Low 1,154.98
    • Prev. Close 1,170.87
    • 52 Wk. High 1,164.94
    • 52 Wk. Low 1,154.98
    • P/E N/A
    • Mkt. Cap N/A
  1. Results from the WOW.Com Content Network
  2. Lock ring - Wikipedia

    en.wikipedia.org/wiki/Lock_ring

    A lock ring is a hollow, penannular metal ornament with a central opening. The ring consists of a triangular cross-section, closed with a binding-strip. The ring was typically constructed from four pieces: a split metal tube, two gapped triangular shaped face-plates and a circular binding strip.

  3. Retaining ring - Wikipedia

    en.wikipedia.org/wiki/Retaining_ring

    A retaining ring is a fastener that holds components or assemblies onto a shaft or in a housing /bore when installed - typically in a groove - for one time use only. Once installed, the exposed portion acts as a shoulder which retains the specific component or assembly. Circlips are a type of retaining ring. Circular push-on retaining rings may ...

  4. Lock and key - Wikipedia

    en.wikipedia.org/wiki/Lock_and_key

    A typical modern padlock and its keys. A lock is a mechanical or electronic fastening device that is released by a physical object (such as a key, keycard, fingerprint, RFID card, security token or coin), by supplying secret information (such as a number or letter permutation or password), by a combination thereof, or it may only be able to be opened from one side, such as a door chain.

  5. Keychain - Wikipedia

    en.wikipedia.org/wiki/Keychain

    Keychain. A keychain ( / ˈkitʃeɪn / ⓘ) (also key fob or keyring) is a small ring or chain of metal to which several keys can be attached. The length of a keychain allows an item to be used more easily than if connected directly to a keyring. Some keychains allow one or both ends to rotate, keeping the keychain from becoming twisted, while ...

  6. Piston ring - Wikipedia

    en.wikipedia.org/wiki/Piston_ring

    The piston ring (PR) is a split band pressed against the wall of the cylinder by springs (S) mounted in the inner "junk ring" (JR). The tongue (T) maintains the seal as the ring expands and splits apart. Piston rings are designed to seal the gap between the piston and the cylinder wall. [2] If this gap were too small, thermal expansion of the ...

  7. Washer (hardware) - Wikipedia

    en.wikipedia.org/wiki/Washer_(hardware)

    Washer (hardware) A washer is a thin plate (typically disk-shaped, but sometimes square) with a hole (typically in the middle) that is normally used to distribute the load of a threaded fastener, such as a bolt or nut. Other uses are as a spacer, spring ( Belleville washer, wave washer), wear pad, preload indicating device, locking device, and ...