enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Prism correction - Wikipedia

    en.wikipedia.org/wiki/Prism_correction

    Prism correction is measured in prism dioptres. A prescription that specifies prism correction will also specify the "base". The base is the thickest part of the lens and is opposite from the apex. Light will be bent towards the base and the image will be shifted towards the apex.

  3. Esotropia - Wikipedia

    en.wikipedia.org/wiki/Esotropia

    Where appropriate, prismatic correction can be used, either temporarily or permanently, to relieve symptoms of double vision. In specific cases, and primarily in adult patients, botulinum toxin can be used either as a permanent therapeutic approach, or as a temporary measure to prevent contracture of muscles prior to surgery

  4. Chirped pulse amplification - Wikipedia

    en.wikipedia.org/wiki/Chirped_pulse_amplification

    Chirped pulse amplification ( CPA) is a technique for amplifying an ultrashort laser pulse up to the petawatt level, with the laser pulse being stretched out temporally and spectrally, then amplified, and then compressed again. [1] The stretching and compression uses devices that ensure that the different color components of the pulse travel ...

  5. Maddox rod - Wikipedia

    en.wikipedia.org/wiki/Maddox_rod

    The strength of the prism is increased until the streak of the light passes through the centre of the prism, as the strength of the prism indicates the amount of deviation present. The Maddox rod is a handheld instrument composed of red parallel plano convex cylinder lens , which refracts light rays so that a point source of light is seen as a ...

  6. Optical aberration - Wikipedia

    en.wikipedia.org/wiki/Optical_aberration

    Optical aberration. 1: Imaging by a lens with chromatic aberration. 2: A lens with less chromatic aberration. In optics, aberration is a property of optical systems, such as lenses, that causes light to be spread out over some region of space rather than focused to a point. [1]

  7. Strabismus surgery - Wikipedia

    en.wikipedia.org/wiki/Strabismus_surgery

    Strabismus surgery is a one-day procedure that is usually performed under general anesthesia most commonly by either a neuro- or pediatric ophthalmologist. [1] The patient spends only a few hours in the hospital with minimal preoperative preparation. After surgery, the patient should expect soreness and redness but is generally free to return home.

  8. Strabismus - Wikipedia

    en.wikipedia.org/wiki/Strabismus

    Incomitant strabismus cannot be fully corrected by prism glasses, because the eyes would require different degrees of prismatic correction dependent on the direction of the gaze. Incomitant strabismus of the eso- or exo-type are classified as "alphabet patterns": they are denoted as A- or V- or more rarely λ -, Y- or X-pattern depending on the ...

  9. Distortion (optics) - Wikipedia

    en.wikipedia.org/wiki/Distortion_(optics)

    The Micro Four Thirds system cameras and lenses perform automatic distortion correction using correction parameters that are stored in each lens's firmware, and are applied automatically by the camera and raw converter software. The optics of most of these lenses feature substantially more distortion than their counterparts in systems that do ...

  10. Aberrations of the eye - Wikipedia

    en.wikipedia.org/wiki/Aberrations_of_the_eye

    Aberrations of the eye. The eye, like any other optical system, suffers from a number of specific optical aberrations. The optical quality of the eye is limited by optical aberrations, diffraction and scatter. [1] Correction of spherocylindrical refractive errors has been possible for nearly two centuries following Airy's development of methods ...

  11. Optical proximity correction - Wikipedia

    en.wikipedia.org/wiki/Optical_proximity_correction

    Optical proximity correction (OPC) is a photolithography enhancement technique commonly used to compensate for image errors due to diffraction or process effects. The need for OPC is seen mainly in the making of semiconductor devices and is due to the limitations of light to maintain the edge placement integrity of the original design, after ...