Search results
Results from the WOW.Com Content Network
Nautical chart#Chart correction To a section : This is a redirect from a topic that does not have its own page to a section of a page on the subject. For redirects to embedded anchors on a page, use {{ R to anchor }} instead .
Figure 2. Geometry of a prism compressor Figure 3. Effective pathlength for a prism compressor with A = 100 mm, θ = 55°, and α = 10°. The colors correspond to different values of B, where B = 67.6 mm means that the beam barely hits the tips of both prisms at refractive index 1.6.
The bolometric correction scale is set by the absolute magnitude of the Sun and an adopted (arbitrary) absolute bolometric magnitude for the Sun.Hence, while the absolute magnitude of the Sun in different filters is a physical and not arbitrary quantity, the absolute bolometric magnitude of the Sun is arbitrary, and so the zero-point of the bolometric correction scale that follows from it.
To a related topic: This is a redirect to an article about a similar topic.. Redirects from related topics are different than redirects from related words, because a related topic is more likely to warrant a full and detailed description in the target article.
In statistical quality control, the CUSUM (or cumulative sum control chart) is a sequential analysis technique developed by E. S. Page of the University of Cambridge. It is typically used for monitoring change detection . [ 1 ]
In engineering, the Moody chart or Moody diagram (also Stanton diagram) is a graph in non-dimensional form that relates the Darcy–Weisbach friction factor f D, Reynolds number Re, and surface roughness for fully developed flow in a circular pipe. It can be used to predict pressure drop or flow rate down such a pipe.
In fluid dynamics, the Cunningham correction factor, or Cunningham slip correction factor (denoted C), is used to account for non-continuum effects when calculating the drag on small particles. The derivation of Stokes' law , which is used to calculate the drag force on small particles, assumes a no-slip condition which is no longer correct at ...
In most current use cases, the letters A–F or a–f represent the values 10–15, while the numerals 0–9 are used to represent their decimal values.. There is no universal convention to use lowercase or uppercase, so each is prevalent or preferred in particular environments by community standards or convention; even mixed case is used.