Ads
related to: railroad switch fish plate
Search results
Results from the WOW.Com Content Network
A fishplate, splice bar or joint bar is a metal connecting plate used to bolt the ends of two rails into a continuous track. The name is derived from fish, [1] a wooden reinforcement of a "built-up" ship's mast that helped round out its desired profile. [2] The top and bottom faces taper inwards along their short dimensions to create an even ...
A right-hand railroad switch with point indicator pointing to right Animated diagram of a right-hand railroad switch. Rail track A divides into two: track B (the straight track) and track C (the diverging track); note that the green line represents direction of travel only, the black lines represent fixed portions of track, and the red lines depict the moving components.
A rail fastening system is a means of fixing rails to railroad ties ( North America) or sleepers ( British Isles, Australasia, and Africa ). The terms rail anchors, tie plates, chairs and track fasteners are used to refer to parts or all of a rail fastening system. The components of a rail fastening system may also be known collectively as ...
1900 to 1945. At the beginning of the twentieth century, the form of British track had converged on the use of wrought iron bullhead rails supported in cast iron chairs on timber sleepers, laid in some form of ballast. In North America, the standard was T-rails and tie plates fastened to timber crossties with cut spikes.
Plate rail was an early type of rail and had an 'L' cross-section in which the flange kept an unflanged wheel on the track. The flanged rail has seen a minor revival in the 1950s, as guide bars , with the Paris Métro ( Rubber-tyred metro or French Métro sur pneus ) and more recently as the Guided bus .
In North America and the United Kingdom, rail is graded in pounds per yard (usually shown as pound or lb ), so 130-pound rail would weigh 130 lb/yd (64 kg/m). The usual range is 115 to 141 lb/yd (57 to 70 kg/m). In Europe, rail is graded in kilograms per metre and the usual range is 40 to 60 kg/m (81 to 121 lb/yd).
A section of strap rail that has come loose and curled upward due to the weight of railway cars passing over it [230] Speeder, motorcar, trackcar, putt putt, or golf cart. A privately owned speeder on display. A small, motorized track inspection vehicle [231] SpongeBob, SpongeBob Cab, or SpongeBob SquareCab.
Signal types. North American signals are commonly of three types. Absolute – Absolute signals are usually connected to an interlocking controlled by a block operator or train dispatcher. Their most restrictive aspect is "stop" and trains cannot pass them at stop unless they obtain special authority.
A harp switch stand is a type of railroad switch stand that was most common during the 19th century in the United States. The name derives from the characteristic shape of the stand. The harp stand was typically used in conjunction with the stub switch. It remained in use longest among narrow gauge railroads such as the Denver & Rio Grande well ...
Disposition. Three preserved, remainder scrapped, 1 replica on display. The FM H-10-44 was a switcher locomotive produced by Fairbanks-Morse from August, 1944–March, 1950. The units featured a 1,000-horsepower (750 kW), six-cylinder opposed piston prime mover, and were configured in a B-B wheel arrangement mounted atop a pair of two-axle AAR ...